Installation is simple and the compact components fit almost anywhere, allowing just about any hot rod, classic truck, or muscle car to be equipped with much safer electric power brakes for modern driving safety. Furthermore, you do not have to worry about your performance modified engine with its aggressive camshaft and not having enough vacuum signal to allow the vacuum brake booster to work properly for power brakes. Installation is greatly simplified over the traditional large diameter brake vacuum booster that takes up valuable engine bay and firewall real estate. One of the easiest ways to add power brakes to your ride is with one of our compact electric power brake booster and master cylinder kits. Steering and braking are a bit more involved, but far from impossible either. Updating your vehicle's lighting is rather simple, as is making it more visible to other drivers. We want to enjoy our rides and make it to our destination safely, and to do so improvements in lighting, braking, steering, and visibility are tops on our list. Modern Power Brakes Without Relying on a Vacuum SignalĪs much as we all love to drive our hot rods, muscle cars, and classic trucks, there are a few safety aspects that we feel require improvement to handle the demands of today's traffic, road speeds, and distracted drivers.
Compatible with all DOT3, DOT4, and DOT5 brake fluid types.Includes 4 feet of 3/8-inch fluid supply hose to plumb master cylinder to electric brake booster.Master cylinder fluid ports are standard 3/8-24 inverted female flare no special adapters needed.Electric power brake booster is very quiet and includes rubber isolators for mounting.Polished aluminum master cylinder and cap looks great under hood.
Power booster master cylinder full#
Hydraulic accumulator stores up to 15 full assist brake applications once 12-volt power removed.Eliminates unsightly and bulky vacuum power brake booster from firewall.Perfect solution for engines with low vacuum signals, diesel engines, and boosted applications.Master cylinder is compact enough to use directly on firewall, under dash, or under floor.1-3/16-inch bore master cylinder designed for use with disc/disc braking system.System provides up to 2,000 psi of brake line fluid pressure to brakes.12-volt electric power brake booster can be mounted almost anywhere.Learn more about proportioning and residual pressure valves with our Toolbox article.Residual pressure valves such as 2 psi PN 91031346 will be required if mounting the master cylinder on the frame rail under your floor.A proportioning valve will be required, and we suggest an adjustable valve such as PN 91031355 or proportioning valve block PN 91031358.May draw up to 14 amps at maximum pressure, so be sure to protect the wiring circuit appropriately.This kit is a disc/disc application for disc/drumapplications refer to PN 10410562.The kit’s brake master cylinder may be too big for some street cars and small hot rods, but will work well for muscle cars and classic trucks.The electric brake power booster connects to the rear most 3/8-24 IFF port located on the master cylinder.The low-pressure feed line fitting is located on the driver's side of the master cylinder when mounted to the firewall and the kit includes a 4-foot section of 3/8 inch hose for it.The master cylinder’s front and rear brake fittings and the pressure line fitting to the electric brake power booster are all 3/8-24 IFF.
0 kommentar(er)
